Aluminum CNC Hop-Up Chamber for M249 Replicas
- Purpose: M249 replicas
- Material: 7075-T6 aviation aluminum
- Weight: 22g
- Color: silver
- Manufacturer: EPeS Airsoft
The product does not constitute ballistic protection and has no other protective properties. It is not intended for use in protective purposes, including during tactical/war/ASG games.
The use of the product for ballistic protection and/or for other protective purposes, including the use during tactical/war/ASG games, is the use of the product contrary to its intended use, in which case the buyer does so solely at his own risk.
The vendor is not liable for damage to the product, that might result from the use of the product contrary to its intended purpose, this also applies to all possible health consequences (bodily harm) for the user (buyer) or damage to property. Moreover, a misuse of the product will void the warranty on the product.
The vendor is liable to the buyer under the warranty for product defects (in the event of such defects) only if the buyer/user uses the product for its intended purpose, i.e. for purposes other than protective purposes, including the use during tactical/war/ASG games.
The lack of any protective properties of the product is a feature, not a product defect, and therefore it does not constitute a physical defect of the product within the meaning of the Polish Civil Code.
Aluminum CNC Hop-Up Chamber for M249 Replicas
Features:
- designed for M249/Minimi replicas by SA, A&K, P&J, CA, Cybergun
- made out of aviation duralumin EN AW 7075-T6 with a H+PTFE surface finish
- precise hop-up adjustment
- clearly marked direction of adjustment
- modern construction of the chamber interior - tested with the majority of rubber buckings available on the market
- designed for AEG hop-up buckings with a standard collar length - to fit the bucking with a longer collar to the chamber, you can use the included washers
- adjustment of the chamber clearance in relation to the gearbox opening is done using the attached o-rings (two sizes)
- removable pin stabilizing the chamber with the feeder
- made in the Czech Republic
Set contains:
- Hop Up chamber
- Pressure adjustment ring
- spacer
- 2 pcs of O-rings for attaching the adjusting ring (9×1.5 mm)
- 2 pcs of o-rings to adjust the clearance of the chamber in relation to the gearbox hole (sizes 6×1 mm and 9×1 mm)
- 2 pcs of spacers for the collar of the hop-up bucking (0.1 + 0.2 mm)
- 4 pcs of screws for fixing the barrel inside the hop-up chamber (2 pcs. M3×5 + 2 pcs. M3×4)
- Screw for fixing the hop-up chamber inside the outer barrel housing (M3×12)
- Longer replacement stabilizing pin