ETU Perun V2 Hybrid kit (rear wiring)
- Brand: Perun
- color: White
- made for: Replicas z gearboxem V2
- weight [g]: 20
The product does not constitute ballistic protection and has no other protective properties. It is not intended for use in protective purposes, including during tactical/war/ASG games.
The use of the product for ballistic protection and/or for other protective purposes, including the use during tactical/war/ASG games, is the use of the product contrary to its intended use, in which case the buyer does so solely at his own risk.
The vendor is not liable for damage to the product, that might result from the use of the product contrary to its intended purpose, this also applies to all possible health consequences (bodily harm) for the user (buyer) or damage to property. Moreover, a misuse of the product will void the warranty on the product.
The vendor is liable to the buyer under the warranty for product defects (in the event of such defects) only if the buyer/user uses the product for its intended purpose, i.e. for purposes other than protective purposes, including the use during tactical/war/ASG games.
The lack of any protective properties of the product is a feature, not a product defect, and therefore it does not constitute a physical defect of the product within the meaning of the Polish Civil Code.
Perun V2 Hybrid ETU Kit
A high-quality optical-magnetic kit of the Electronic Trigger Unit type produced by Polish company Perun.
The Perun Hybrid system offers a number of features to improve the replica's performance and customise the replica to suit your needs. Intuitive programming via a trigger and selector allows the replica to be reconfigured even during gameplay.
In addition, the Perun Hybrid, thanks to the use of optical and magnetic sensors, allows the elimination of many wear-prone, moving Gearbox parts. As a result, zit significantly extends the life and reliability of the replica.
The kit fits most Tokyo Marui standard V2 gearboxes without the need for modifications. Exceptions are listed in the manual.
Functions of the system:
-Adjustable trigger sensitivity -The system offers 5 levels of sensitivity
-Programmable fire modes -Single, series or automatic fire can be set at each selector position (except "protected").
-Active brake -Stops the motor after each shot, preventing spring compression and overspin.
-Precocking -The plunger will remain in the rear position after each shot, ensuring that the shot is fired as soon as the trigger is depressed. To release the spring after using precocking, depress the trigger and hold it for 2 seconds.
-Two-stage trigger -When this feature is activated, a light pull of the trigger results in single or series fire, while a deeper pull results in series or continuous fire. The following combinations are possible: single - series, single - automatic, series - automatic.
-Binary trigger - Allows you to easily fire double shots in single fire mode. When enabled, single shots will be fired not only when the trigger is pressed, but also when the trigger is released.
-Reduced rate of fire
-DMR Mode -Institutes minimum intervals between shots to meet the requirements for DMR replicas at certain competition venues.
-Low Battery Alert -If the battery voltage drops to a dangerously low level, the user will be notified with short beeps repeated every minute.
-DSG Mode Piston gear detection mode designed specifically for DSG gears.
-Diagnostic system Continuously checks the status of the electronics and the replica. In the event of a problem, it will immediately provide information on what might have caused it, making it easier to rectify the fault.
-Electronic fuse -Protects the replica and the battery in a serious failure. It will automatically disconnect the battery if a short circuit is detected or a jam occurs in the gearbox.
Features of the system:
-All settings are changed using only quick and easy to remember combinations of fire selector and trigger movements. The circuit communicates with the user via beeps and a multi-coloured LED.
-Perun V2 Hybrid works seamlessly with any battery from 7V to 17V. It can be used with the most extreme configurations, with no restrictions on spring power.
-Optical and magnetic sensors eliminate many moving parts that are prone to damage and wear, thus increasing reliability.
Polish company Perun entered the ASG market in 2016. Thanks to the use of high-quality materials, well-thought-out designs, quality control constant contact with players and service technicians, the manufacturer offers Mosfet and ETU systems of the highest order.