PL-2 Valkyrie XHP35 Flashlight
- Maximum Power: 1200 lumens Range: 235 m Material: Aerospace aluminum Weight: 80 g (without batteries) Measurements: 82.5 x 32.5 x 36.5 mm Power Source: 2 x 3 V CR123 batteries Manufacturer: Olight
The product does not constitute ballistic protection and has no other protective properties. It is not intended for use in protective purposes, including during tactical/war/ASG games.
The use of the product for ballistic protection and/or for other protective purposes, including the use during tactical/war/ASG games, is the use of the product contrary to its intended use, in which case the buyer does so solely at his own risk.
The vendor is not liable for damage to the product, that might result from the use of the product contrary to its intended purpose, this also applies to all possible health consequences (bodily harm) for the user (buyer) or damage to property. Moreover, a misuse of the product will void the warranty on the product.
The vendor is liable to the buyer under the warranty for product defects (in the event of such defects) only if the buyer/user uses the product for its intended purpose, i.e. for purposes other than protective purposes, including the use during tactical/war/ASG games.
The lack of any protective properties of the product is a feature, not a product defect, and therefore it does not constitute a physical defect of the product within the meaning of the Polish Civil Code.
PL-2 Valkyrie XHP35 Flashlight
A firearm flashlight powered by two CR123A batteries that thanks to Cree XHP35 HI diode provides a beam of light with a strength of 1200 lumens and a range of 235 meters. Valkyrie is equipped with a mounting rail compatible with 22 mm standard (Weaver / Picatinny / MIL-STD-1913). A system of steel clamps allows for the rapid attachment of the flashlight to a weapon.
The casing of the flashlight was made from aerospace aluminum covered with hard anodizing in black color. In addition, the head of the flashlight is protected by steel crown in the front. Such construction allowed to increase the resistance to fall damage to a height of 1 m. Implemented seals guarantee IPX7 Water Resistance. Batteries are installed after the removal of the flashlight’s head.
The heart of the flashlight consists of advanced electronics which steer the power drain directed to the XML diode. Thanks to that, the flashlight can cast a light with the same power until the complete discharge of the battery. Active Thermal Management system protects the diode from overheating whilst operating in the most powerful mode (1200 lumens). After 90 seconds, it reduces the voltage and stabilizes the light on a level of around 600 lumens. After the deactivation of the flashlight, cooling off and reactivation, the flashlight will once again operate in the most powerful mode.
The flashlight is turned on using a comfortable switch located in the rear part. The switch is double-sided, which allows the flashlight to be used by both left- and right-handed Users.
Modes of operation/operation time (2 x CR123 battery):
- 1200-600 lumens / 1.5 min + 70 min
- strobe / 70 min
The flashlight comes with two CR123A 1600 mAh batteries.
Specification:
Light Source: Cree XHP35 diode
Effective Range: 235 m (wide beam)
Power Source: 2 x 3 V CR123 batteries
Casing: Aerospace aluminum with hard, type III anodizing
Switch: Electronic (double-sided)